A straight flashing light support, equipped with a fixing tab, allowing you to aim thanks to the two holes on the ends.
The multifunctional 18W flashing light is extremely small, since it only fits between two fingers!
A spot that is not lacking in power! 120 Watts Max for 24 LEDs in CREE® technology, i.e. 12,000 Lumens in total!
This LED bar measures no less than 152cm! In other words, it can be seen from far away... Equipped with 168 high quality multifunction LEDs.
A Ledpowerlight exclusive. The magnetic 18W Multifunction mini flashing light is extremely small.
This bar has 78 CREE® XBD LEDs for a total of 234w (18,000 Lumens), in other words, you will have enough to light.
60W CREE® LED bar This spotlight, with a power of 60 watts (5160 Lumens), will be the ideal companion to your tractor or other construction machine, or your 4x4.
This LED cone works with solar energy and has a battery life of 120 hours!
This 9-LED 27W work light is used for most of the time for handling. Thanks to its power it develops no less than 1775 lumens.
It allows you to indicate the dangerous zone for pedestrians, by projecting a flashing point on the ground, at a rate of 3 per second.
Light discs with 9 different functions, including S.O.S and stroboscope, rechargeable in 3 hours max.
This multifunctional aluminum marker light can be used on truck, bus, construction equipment, forklift etc...
The Meanwell HVG-150-24 transformer is an essential accessory for installing low-voltage LED spotlights (24VDC) on an 180-528VAC power supply.
The 3-function backup alarm has the BEEP of recoil (107dB), the breath of the ALIEN (92dB), but also the SILENCE function.
This rechargeable LED lamp is very practical! With a transformer for each type of load (12v-24V or 220V).
Bobcat® compatible aluminum LED front light (Right or Left), with work light function and headlight call, with a power of 90W!
This Magnetic Multifunction LED Flashing Light + Alarm, 10-110VDC compatible.
A straight flashing light holder, to be aimed, with built-in socket and protective cap.
This LED spotlight holder is mounted on a tube, such as a forklift cabin, and thus prevents drilling into it.
The Blue Spot 4G is the very latest version of the famous Blue Spot. Equipped with 6 LEDs, it is a really very powerful spot.
This 30W Logo Projector projects an ultra-sharp logo on the ground. It is completely customizable.
48W LED work light, equipped with a quick plug, identical to that of the flashing lights, in order to dismantle it at the end of the day.
The Blue Spot Arrow is a safety element in its own right, it projects a direction arrow onto the ground.
36w strobe work light (12 CREE® LEDs x 3W), i.e. 18w central and 18w in strobe or night light.
The Forklift Laser Guide is equipped with an adjustable laser beam that projects in front of the forklift forks.
The Meanwell ELG 150 24A transformer is an essential accessory for installing low-voltage LED spotlights (24VDC) on a 200-305VAC power supply
The small version of the ARC spot, it also allows you to draw an ARC of a circle on the ground, but rather on small machines such as AGV robots for example.
This Blue Spot Mini 10W is, as the sound suggests, very small, but it has everything of a big one!
10-110v flashing light. Widely used on forklifts, it is very practical because of its size.
The LED Flash Corner from Ledpowerlight® has 6 different functions. It is used to be fixed in corners.
Operates over a 10-30VDC range. It has 11 functions that can be changed very easily, thanks to a button located below.
Red Line Laser Light Compatible with any forklift (gas, diesel, electric...) this laser projector has a very high power.
This 56W Multifunctional and magnetic Ledpowerlight® Mini LED bar operates over a range of 10-30VDC.
240° 54W 3D Work Light! This spot is equipped with 3 facets of 18 LEDs in total.
The multifunction 6-LED penetration light is a high-power light signaling solution.
Its function consists in projecting an arrow on the ground, in order to indicate the direction of travel of the vehicle.
Allows you to project a point on the ground in front of the forklift, and therefore promotes the attention of pedestrians in warehouses.
The flashing light alarm has the BEEP back-up (92-107 db) and the LED Flash function.
It is the Blue Spot must in terms of power. As a result, it will also be ideal for overhead cranes!
This spot is the new generation of the famous Classic Blue Spot, it projects a point on the ground and thus promotes the attention of pedestrians.
Equipped with 2 completely autonomous lights, this kit allows you to replace the rear lights of any vehicle in a few seconds.
The FX series lights have a very modern design, and are equipped with ultra-powerful LEDs.
BLUEMAX 4 — Light power at the service of your safety!
This front turn signal for a forklift is equipped with 13 very powerful LEDs, but also with a pure white daytime running light, in order to work safely!
This Forklift Multifunction Rear Light is equipped with 18 very powerful LEDs.
This aluminum solar plot is intended to be embedded in the ground, in order to warn road users of an imminent danger or a slowdown.
This 32W Multifunctional and magnetic LED flashlight (ISO-4148 standard) Ledpowerlight®, operates over a range of 10-30VDC.
The Red Line Visio® allows you to project an adjustable line on the ground, in order to protect pedestrians.
The Laser Guide with Removable Battery for Forklift Fork is equipped with a laser beam.
The Razor Line® develops 24W thanks to 8 LEDs of 3W each, and allows you to project a line of 6 meters on the ground (at a height of 2.5m)
ECER10/R3/R6/R7/R23/R38 certified Rectangle LED Truck Tail Light Built to last, it is equipped with very high quality components.
Straight flashing light holder with round support, allowing you to aim thanks to the three holes located on the perimeter.
The penetration light offers no less than 18 functions selectable by wire contact. In addition, it is equipped with 3 high quality LEDs of 3 watts each.
This highly magnetic support allows the installation of all types of spots on 8mm nuts.
5 LED CREE® headlamp, rechargeable, thanks to two 18650 batteries (included), and equipped with 5 very powerful CREE® XML-T6 LEDs.
Discover the X3-180 lamp, your ideal ally for all your work. Foldable, lightweight and highly portable
The ARC LED Spot allows you to draw an ARC of a circle on the ground, very bright, because it is a very powerful spot.
This 6-pin rechargeable and magnetic safety case will allow you to define a very visible security perimeter.
Angled flashing light holder with mounting bracket, allowing you to aim thanks to the two holes on the ends.
The Safety Vest with Pockets and Insert from Ledpowerlight, allows great visibility and therefore increased safety on construction sites or in warehouses.
The LED Safety Vest* from Ledpowerlight allows very high visibility and therefore increased safety on construction sites or warehouses.
The Sequential Blue Spot projects 4 points on the ground, 3 of which are sequential.
.jpg)
